Selecting The Installation Location; Installing The Stove - Dometic A100 Bedienungsanleitung

Origo
7.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
•
Select a well-ventilated location for the device.
Ensure a minimum distance (fig. 5, page 5) of
•
– 50 mm to side and back walls
– 750 mm between stove coil element and horizontal surface above the stove
•
Avoid cabinet storage space above the stove.
Otherwise you risk burns and fire when reaching over the stove.
•
Do not operate the device in spaces where danger of explosion is present.
7.2

Installing the stove

A
NOTICE! Danger of damaging the device!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Cut a rectangular hole into the countertop (dimensions see following table):
Model
A100
A200
➤ Open the top and remove the canisters (see "Taking out the canister" on
page 14).
➤ Open up the hinge part in the back of the stove.
➤ Place the stove according to fig. 3, page 4.
➤ Mark the drill holes.
Use the fastening holes in the hinge as a template.
➤ Pre-drill the holes into the countertop where marked.
➤ Fasten the stove by screwing flat head screws through each drill hole in the hinge
(fig. 4 2, page 4).
➤ Install the magnetic locker in the front of the cutout (fig. 3 1, page 4).
➤ Place a class B-1 fire extinguisher in reaching distance.
EN
Dimensions W x D x H
255 x 150 x 340 mm
485 x 150 x 340 mm
Mounting the stove
13