Oase Air Flo 230 V, 1.5 kW Gebrauchsanleitung Seite 22

- EN -
Switching on the automatic cut-out device AirFlo 230 V, 1.5 kW / 400 V, 1.5 kW
The automatic cut-out device switches off the unit in the event of overload. First find and remedy the cause of the over-
load before switching the unit on again.
How to proceed:
 J
Open the cut-out box and set the switch lever of the automatic cut-out device to the "ON" position.
Close the cut-out box and establish the power connection.
Switching on the motor (overload) protection switch AirFlo 400 V, 4.0 kW
The motor (overload) protection switch switches off the unit in the event of overload. First find and remedy the cause of
the overload before switching the unit on again.
How to proceed:
 K
Actuate the right-hand switch (green) to reset the motor (overload) protection switch.
– The left-hand switch (red) is for performing a function test. When this switch is actuated, the motor (overload) pro-
tection switch must trip.
Establish the power connection.
Storage/overwintering
The unit is not frost-proof and has to be removed and put into storage if minus temperatures are expected.
How to correctly store the unit:
• Thoroughly clean the unit, check it for damage and replace any damaged parts.
• Protect electrical connections from moisture and dirt.
• Protect open plug connections from moisture and dirt.
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided for
this purpose.
22