Sirius SILT28 ROLL LAMP Bedienungsanleitung Mit Montageanweisungen Seite 20

MODE DE FONCTIIONNEMENT
Confiiguratiion standard:
La configuration d'usine prévoit que tous les
systèmes " hotte - radiocommande " aient le
même code de transmission. Si deux systè-
mes "hotte – radiocom- mande" sont installés
dans la même pièce ou à proximité des systè-
mes ayant le même code de transmission, ils
pourraient être influencés et il faudrait chan-
ger le code d'une seule radiocommande.
Generatiing a new transmiissiion code:
The radio control system is provided with
preset codes. Should new codes be requi-
red, proceed as follows: Press simultaneously
buttons:
for two seconds. When Leds light on, press
buttons:
(within 5 seconds). Leds flashing 3 times in-
dicate
the procedure is completed.
WARNING! This operation deletes perma-
nently the preset codes.
Learniing the new transmiissiion code:
Once the transmission code is changed in the
radio control unit, the electronic central unit
of the cooker hood must be made to set the
new code in the fol- lowing way:
Press the main power-off button of the hood
and then restore power to the electronic con-
trol unit. Within the next 15 seconds, press
the Liight Button
tral unit with the code.
Reset of the Factory confiiguratiion:
To restore the Factory configuration, follow
the pro- cedure described below: press si-
multaneously buttons:
to synchronise the cen-
for 2 seconds. When Leds light on, press but-
tons:
(within 5 seconds). Leds flashing 6 times in-
dicate the procedure is completed.
WARNING! This operation deletes perma-
nently the preset codes.
Emergency button:
In the event that the radio control does not
work, use the emergency button to switch
the appliance off. After any necessary repairs
have been performed, reset the emergency
button.
WARNIING
The battery should be replaced every year
to guarantee the optimal range of the
transmitter.
To replace the exhausted battery, take
the plastic lid off, remove the battery and
replace it with a new one, observing the
correct battery polarities.
Used batteries should be discarded in
special collection bins.
The below product:
RC001 Radiio Controll
complies with the specifications set out in
the R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modifications which
have not been expressly approved by the
holder of the legal conformity certificate
may invalidate the user's rights relating to
the operation of the device.
The products are endowed with an electronic
device which allows the automatic switching
off after 4 hours working from the last ope-
ration.
20
Rev. 0 26/08/14