Digital I/O Menu; Alarms Menu - Videotec ULISSE Bedienungsanleitung

10.1.11 Digital I/O Menu

1. Alarms: Access the alarm menu.
Washer: Access the Washing System menu.
2.
DIGITAL I/O
------------------------
1>ALARMS
2 WASHER
Fig. 115

10.1.11.1 Alarms Menu

01-04. Alarms 1-4: Access the menus, which
allow you to modify the Alarm parameters from
1 to 4.
05. Alarms State: Access the Alarm Status menu.
ALARM
------------------------
1>ALARM 1
2 ALARM 2
3 ALARM 3
4 ALARM 4
5 ALARMS STATE
Fig. 116
This is a dynamic self-configuration menu based on
the Pan & Tilt model.
56
The single alarms menu allows you to configure the
following values:
Type: Type of contact, normally closed (N.C.) or
1.
normally open (N.O.).
Action: The type of action carried out by P&T
2.
when the alarm triggers (Off, Msg, PTZ Stop,
Wiper, Washer, Scan, Patrol, Autopan, Relay, Ir
>
>
Filt). The OFF parameter disables the alarm.
Number: The preset to be reached when the
3.
alarm's type of action is Scan.
Text: This message is displayed when the alarm
4.
is active.
ALARM 1
------------------------
1>TYPE :
2 ACT. :
3 NR.
4 TEXT : ALARM 1
Fig. 117
>
>
This is a dynamic self-configuration menu based on
>
the choice made and shows the parameters on which
>
it is possible to operate.
>
The Alarm Status menu shows the input status of the
alarms (Closed, Open).
ALARMS STATE
------------------------
ALARM 1
ALARM 2
ALLARME 3
ALLARME 4
Fig. 118
N.C.
SCAN
: 1
CLOSED
OPEN
CLOSED
CLOSED
MNVCUPTDMB_1511_EN