Rear Panel - Hughes & Kettner WARP T Bedienungsanleitung

WARP T - MANUAL
CLEAN CHANNEL
PRESENCE
Controls CLEAN channel overtones.
FX ON
Routes the external effect to the CLEAN channel.
TREBLE, MID, BASS
These knobs voice (shape the tone) of the CLEAN
channel.

2.2 REAR PANEL

You'll find the following components mounted
on the black sheet metal panel on the back of
the amp:
MAINS
Equipped with a fuse compartment, this Euro
mains socket provides power to your amp. Before
plugging into the wall outlet, make certain the
amp's voltage rating matches your local AC voltage
rating. To find out your amp's voltage rating, refer
to chapter 7.0 TECHNICAL SPECIFICATIONS.
FOOTSWITCH
This port accepts the two-way Hughes & Kettner
FS-2 Stageboard, which lets you switch CLEAN and
WARP channels and FX ON remotely. This feature
comes in particularly handy on stage when you
need to switch on the fly.
8 8
VOLUME
Determines the CLEAN channel's volume and
compression levels.
INPUT
Located on the far right, this jack accepts your
guitar cord's 6.3 mm (1/4") plug.
FX SEND
If you want to employ an effect device, connect
this jack to the signal processor's input. You can
also use this output to send the signal to an outboard
power amp or a RED BOX
into a mixer. For more on this, read section
4.3 HOW TO CONNECT AN EFFECTOR.
FX RETURN
Connect this jack to the effect device's output.
FX –10dB
This button reduces the FX SEND jack's output level
by 10 dB and increases the FX RETURN jack's input
sensitivity by 10 dB to adapt the FX loop to the
®
effect device's input level. Press this button when
using effect devices with inputs designed to
accept instrument levels.
® to patch your signal