For The Charger; Residual Risks; Machine Information - Ferm CDM1126 Übersetzung Der Originalbetriebsanleitung

Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.

For the charger

Intended use
Charge only 10.8V MAX.1.5Ah Li-ion type
rechargeable battery packs. Other types of batteries
may burst causing personal injury and damage.
a) The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
b) Children being supervised not to play with
the appliance
c) Do not recharging non-rechargeable batteries!
d) During charging, batteries must be placed in
the well ventilated area!

Residual risks

Even when the power tool is used as
prescribed it is not possible to eliminate all
residual risk factors. The following hazards
may arise in connection with the power tool's
construction and design:
a) Health defects resulting from vibration
emission if the power tool is being used
over longer period of time or not adequately
managed and properly maintained.
b) Injuries and damage to property to due to
broken accessories that are suddenly dashed.
Warning! This power tool produces an
electromagnetic field during operation.
This field may under some circumstances
interfere with active or passive medical
implants. To reduce the risk of serious or
fatal injury, we recommend persons with
medical implants to consult their physician
and the medical implant manufacturer
before operating this power tool.

2. MACHINE INFORMATION

Intended use
This cordless drill is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
Technical specifications
Model No
Charger
Input of charger
Output of charger
Rechargeable battery pack
Battery charging time
Chuck capacity
Torque settings
No load speed
Position L:
Position H:
Weight (incl. battery)
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screwdriving without impact)
Hand-arm vibration a
h,D
(Drilling into metal)
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
CDM1126
CDA1091
200-240V~ 50-60Hz
Max.1A
12.6V DC 1.5A
10,8 V Li-ion 1.5Ah
72 minutes
1.0 - 10 mm
18 + Drill mode
0-400 /min
0-1400 /min
1,0 kg
65.17 dB(A), K=3dB(A)
76.17 dB(A), K=3dB(A)
0.846 m/s K=1.5 m/s
2 2
1.739 m/s K=1.5 m/s
2 2
5