Operation; Attaching The Disc Guard Cover Using The Quick-Release Fastener; Attaching The Auxiliary Handle; Attaching And Replacing Roughing / Grinding / Cutting Discs - Parkside PWS 230 B2 Originalbetriebsanleitung

The appliance must always be kept clean, dry
GB
and free from oil or grease.
IE
■ Remain alert at all times! Always pay attention
to what you are doing and act with common
sense. Never use the appliance when you are
distracted or don't feel well.
Wear protective glasses!
Wear a dust mask!

Operation

Attaching the disc guard cover using
the quick-release fastener
WARNING – RISK OF INJURY!
► Pull the mains plug out of the mains socket
before you carry out any task on the device.
RISK OF INJURY!
► Always use the angle grinder with the blade
guard . The blade guard should be installed
securely. Set it so that the highest possible
degree of safety is achieved, e.g. the smallest
possible part of the grinding disc is exposed
to the operator. The blade guard
signed to protect the operator from fragments
and accidental contact with the grinding tool.
RISK OF INJURY!
► Ensure that the guard
edge is beyond the angle of the auxiliary han-
dle (see Fig. B). Otherwise you could injure
yourself against the grinding or cutting disc.
♦ Open the clamping lever
♦ Insert the disc cover guide
projection
♦ Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
♦ Close the clamping lever
the disc guard cover
10
is attached so that its
.
with the coded
in the coded groove
into the desired
must always be facing
to firmly clamp
in place. If necessary
the clamping force of the connection can be
adjusted by tightening or loosening the adjuster
screw
sits firmly on the spindle collar.

Attaching the auxiliary handle

CAUTION!
► For safety reasons this device must always be
used with the auxiliary handle
Otherwise you could become injured. Screw
the auxiliary handle
the top of the head of the device.
Attaching and replacing roughing /
grinding / cutting discs
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fit
on to the mounting flange without play. Do not use
a reducer piece or adapter.
■ Check the condition of the roughing / grind-
is de-
ing or cutting discs. They must be free of dam-
age, moisture or cracks. Otherwise they could
break up during use and cause injury.
NOTE
► Always ensure the discs are free of dirt
before use.
■ Use only abrasive consumables or tools with an
allowable speed at least as high as the no-load
speed of the device.
■ DANGER OF INJURY! Press the spindle lock
button
.
has reached a standstill.
♦ Press the spindle lock button
♦ Release the clamping nut
spanner
♦ Place the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
. Ensure that the disc guard cover
on the left, right or on
Always wear protective gloves when
changing cutting/rough grinding discs.
Roughing / grinding and cutting discs
become hot during use. Do not touch
them until after they have cooled down.
only after the mounting spindle
to block the drive.
using the Two-pin
(see Fig. D).
with its labelled side
in place.
PWS 230 B2