Water Supply; Interrupting Operation - Kärcher K 5.86 M Bedienungsanleitung

"
Push clip in until it engages and check that it
is securely fastened by pulling on the HP ho-
se.
"
Remove cable tie and unroll HP hose

Water supply

Water supply from mains
For connection values, see type plate/technical
data.
Observe regulations of water supplier.
"
Use a fibre-reinforced hose (not included)
with a standard coupling: - Minimum diame-
ter, 1/2 inches (13 mm). - Minimum length,
7.5 m.
"
Screw the coupling unit (supplied) to the water
connection on the appliance.
"
Push the water supply hose onto the coupling
unit, then connect it to the tap.
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage the
HP pump.
If the water supply is not clean, the Kärcher water
filter must be used (special accessory).
Drawing in water from open reservoirs
When fitted with the appropriate accessories, this
high-pressure cleaner can draw in surface water,
e.g. from water butts or ponds (max. suction
height 0.5 m).
"
Use the Kärcher water filter to protect the HP
pump and accessories (special accessories,
order no. 4.730-059). This filter removes dirt
from incoming water.
"
As the standard coupling system is not suita-
ble for use in suction mode, the Kärcher suc-
tion hose with integrated filter should be used
instead (special accessory, order no. 4.440-
238) and suspended inside the water butt.
"
Remove air from appliance before operation:
Switch on the appliance when the HP hose is
not connected and run it until the water which
discharges from the HP outlet is free of
bubbles. Switch off appliance and connect
HP hose.
Start up
"
Screw HP hose on to HP outlet on appliance.
"
Push the appropriate spray lance on to the
handgun and fasten it by turning it to the right
through 90°.
"
Open tap.
"
Plug in mains plug.
10
English
"
Set main switch to "I/ON".
"
Press safety catch on the handgun to release
it and pull lever.
High pressure operation
Risk of injury
The handgun is subjected to a recoil force when
the water jet is discharged. Make sure that you
have a firm footing and are also holding the hand-
gun and spray lance firmly.
Spray lance with Variopower nozzle
"
Carrying out the most common cleaning
tasks.
Operation with detergents is possible with low
pressure (–)
Spray lance with dirt blaster
"
for particularly stubborn stains.
Operation with detergents not possible
Operation with detergent
Note:
Detergent can only be added when the appliance
is being operated in low pressure mode.
All washing brushes supplied by Kärcher are de-
signed for use with detergents.
"
Turn Variopower nozzle until lowest pressure
setting has been reached (–).
DT suction infeed from DT tank
"
During low pressure operation, detergent is
automatically sucked in from the filled deter-
gent tank.
"
Fill the detergent reservoir with Detergent ta-
blet and water or Detergent concentrate and
water (Observe metering recommendations
on the packaging label of the detergent.)
"
Meter out the cleaning agent (cleaning agent
metering valve)
– medium quantity: centre-position
– large quantity: "+" position
– small quantity: "–" position.
Recommended Cleaning Method
1 Spray a small dose of the detergent on the dry
surface, and allow it to react (make sure the
detergent does not dry up).
2 Wash off the loosened dirt using the high-
pressure jet.

Interrupting operation

"
Release the lever on the handgun.
"
During breaks, use the safety catch to secure
the handgun lever.