Replacing The Spool; Using - Westfalia 82 87 27 Bedienungsanleitung

3. Pull as much nylon line as necessary, until the line is reaching the blade
holder (12). So the nylon line can be cut off during rotation of the motor. For
pulling out nylon line, press the nylon line releasing button (13) several
times and pull the nylon line up to the desired
length.
4. Now place the cap (10) on the spool, as
shown in the picture on the right and close
the spool with the cap. Make sure the cap
closes audibly and visibly.
5. If you want to pull out nylon line during work,
tap down the lawn
trimmer several times
on a hard
while the motor is
running until
nylon line is up to the
desired length.

Replacing the Spool

For removing the spool, first press both latches on the
cap inwards and pull out the cap.

Using

 Hold the lawn trimmer approx. 5 cm above the ground and swivel from one
side to the other. Move the lawn trimmer slowly above the ground.
 Do not switch on the trimmer if it stands on the ground. Keep the nylon
lines away from hard objects. You will prevent the nylon lines from being
cut needlessly.
 You can also tilt the lawn trimmer a little bit to cut the lawn.
 If the grass is high, preferably cut in several steps.
Operating
object
the
17