Using The Center On-Screen Display - Sony GDM-4011P Bedienungsanleitung

Navigating the MENU on-screen display
Select a link using the ¨./> and >?// buttons in the
MENU OSD.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select a link.
The selected link turns yellow.
3
Press the button.
The selected OSD appears.
If no buttons are pressed, the MENU OSD automatically
disappears after about 10 seconds.
To close the MENU OSD, select "EXIT" and press the
button.
Adjusting the on-screen display settings
Select an item using the ¨./> buttons and adjust or select
the setting of that item using the >?// buttons.
To select an item, press the ¨. or > button.
The " mark goes to the selected item and the item turns
yellow.
To adjust or set an item, press the >? or / button.
When adjusting an item, the bar length and the figure
increase or decrease.
When setting an item, the p mark turns green.
Getting Started
Customizing Your Monitor
Using the CENTER On-screen
Display
The CENTER settings allow you to adjust the centering of
the picture.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select "
CENTER," and press the
The CENTER OSD appears.
3
For horizontal adjustment
Press the >?// buttons.
/ . . . to move the picture right
? . . . to move the picture left
For vertical adjustment
Press the ¨./> buttons.
> . . . to move the picture up
. . . . to move the picture down
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
The horizontal and vertical centerings are both reset to the
factory settings.
button again.
CENTER
73
26
button again.
9
EN
F
D
ES
I