NUK Eco Control Video Display 550VD Bedienungsanleitung Seite 61

If you have already added a second
camera, you can also select the patrol
mode option in this menu.
9. Use the 25 or
star in front of the available camera
number you wish to use for the new
camera (black symbol).
At this point, you can still exit the
submenu by pressing the
The submenu will close and you will be
returned to the previous submenu.
However, to continue with your settings,
continue with the next step.
10.Press the
selection.
You will be asked to confirm
your selection again.
11.Use the 24 or
button to select "YES" and
press the
confirm.
The screen of the parent unit will
show that the device is ready to
set up the connection and is
searching for the connection link signal.
12.Insert a bent paper clip or similar into the
button recess and press the recessed
button 9 on the baby unit to activate the
connection link signal.
The baby unit will then transmit the
connection link signal for the parent unit
to find.
As soon as the connection with
the new camera
successfully set up, you will hear
a beep and the appropriate symbol will
appear on the screen.
The menu on the parent unit will be
closed and video transmission from the
new camera/baby unit will be shown. The
new camera/baby unit is displayed in the
status bar with a camera symbol and
number.
Notes:
28 button to move the
button 27.
button 26to confirm your
27
button 26 to
has been
– In order to be able to use the patrol
mode (see "Patrol mode" on page 61),
at least two baby units/cameras must
be connected to the parent unit.
– After 15 seconds without any input
from you, the menu will be closed with
the settings unchanged and the parent
unit will return directly to monitoring
mode.
Connection setup failed
If the connection setup failed, the
screen will remain white and a
corresponding warning symbol will
appear after a few seconds. You will also
hear a beep.
The parent unit will then switch back to the
video transmission from the previously
active camera/baby unit.
13.Follow steps 1 to 12 described above
and try again.
Deleting a camera
You can operate up to four baby units
(cameras) connected to the same parent
unit, but only delete three of these. The last
connected camera/baby
connected under the same camera number
and cannot be deleted.
A camera/baby unit can be deleted even if it
is not actively connected to the parent unit
at the time.
To delete or remove a camera/baby unit
from the parent unit, proceed as follows:
1. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Camera menu.
The selected symbol will be shown in red.
3. Press the
submenu.
4. Use the 25 or
star in front of the required setting.
x : delete camera
+ : add camera
59
unit
button 26.
24 or 27 button to
button 26 to view the
28 button to move the
remains