Replacing The Fuse; Technical Specifications - Futurelight PLB-5R Bedienungsanleitung

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX control channels:
DMX512 connection:
Flash-rate:
Color-wheel:
Rotating gobo wheel:
Outside diameter of the gobos:
Image diameter of the gobos:
Maximum PAN-movement 630° :
Maximum TILT-movement 270° :
Beam angle:
Length of base (including handles):
Width of yoke:
Height (head horizontal):
Weight (net):
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
PHILIPS MSD Platinum 5R discharge lamp
FUTURELIGHT ULB-1 Upload box
FUTURELIGHT RDM Director Touch Screen
Please note: Every information is subject to change without prior notice. 08.12.2011 ©
230 V AC, 50 Hz ~
280 W/310 VA
11/13/16
5-pin and 3-pin XLR
13 Hz
9 dichroic plus white, CTO and
CTB correction-filters, UV-filter
8 gobos and open
14 mm
7 mm
in 1.5 s
in 1.0 s
approx. 2°
355 mm
355 mm
480 mm
14 kg
: 45° C
a
(steady state): 85° C
C
0.5 m
0.5 m
T 5 A, 250 V
No. 89101930
No. 51836902
No. 51834850
58/58 00062945, Version 1.0