Personality
Status settings
Address via DMX
With this function, you can adjust the desired DMX-address via an external controller.
• Select "Address via DMX" by pressing Up or Down.
• Press the Enter-button, the display shows "ON" or "OFF".
• Press Up or Down to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address between 1
and 255. When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting address to
57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the starting address to 420,
set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is set.
No DMX status
With the function "No DMX status", you can set different modes if there is no DMX-signal.
• Select "Close, Hold, Auto or Music" by pressing Up or Down.
• Press the Enter-button, the display shows "Close".
• Press Up or Down to select between "Close", "Hold", "Auto" or "Music".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Close
With this function, you can close the shutter and set the device to center position if there is no DMX-signal.
This mode equals the settings Auto = OFF and Music = OFF.
Hold
With this function, the device remains in the last received DMX-program if there is no DMX-signal.
Auto
With the function "Auto", you can set the device to auto run if there is no DMX-signal.
Music
With the function "Music", you can set the device to sound-controlled program-run if there is no DMX-signal.
PAN Reverse
With this function you can reverse the Pan-movement.
TILT Reverse
With this function you can reverse the Tilt-movement.
PAN degree
With this function you can select the PAN-degree.
• Select "PAN degree" by pressing Up or Down.
• Press the Enter-button, the display shows "540".
• Press Up or Down to select the desired degree between "540" and "630".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Automatic PAN/TILT calibration
With this function you can calibrate the PAN/TILT movement to the correct starting position.
Adjust PAN/TILT speed
With this function you can define the PAN/TILT speed. You can select one of 4 different modes.
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select "Mic sensitivity" by pressing Up or Down.
52/58
00062945, Version 1.0