Using As Vacuum Cleaner - Westfalia 25 77 82 Bedienungsanleitung

Using as Vacuum Cleaner

1. Insert the injector nozzle (1), as shown in figure B, into the rear opening of the
device. Pay attention to the direction of the injector nozzle and make sure to
add the two sealing rings at both ends of the connecting piece.
2. Screw the dust bag connector (2) on the rear opening of the device.
3. Put the dust bag (7) on the dust bag connector (2) and secure it with a hose
clamp (8). Close the dust bag with the zipper.
4. If necessary, install the flexible hose (13) at the suction/blow opening (3) of the
device. Secure the hose with a hose clamp (8).
5. Depending on each specific application, put either the suction lance or the
suction brush on the other end of the flexible hose resp. install it directly on the
suction/blow opening of the device.
6. The device is equipped with an air quick coupling adaptor (6). Use the quick
coupling adaptor to connect the air tool with the compressed air supply.
7. Power up the compressed air generator.
8. Press the trigger (4) to start the delivery of air. The farther the trigger is
pressed, the stronger the air jet will be and the stronger the suction power will
be.
9. Lead the suction brush resp. the suction lance in evenly movements across
the surface to be cleaned. The dirt is sucked through the suction opening and
transferred into the dust bag. When vacuum cleaning, always pay attention to
the filling level of the dust bag.
10. Release the trigger to stop the delivery of air.
11. After work disconnect the tool from the compressed air generator.
When the dust bag is filled during operation, hold the tool over a garbage bag,
etc. and open the zipper. Dispose of the contents of the dust bag. Then
carefully close the dust bag with the zipper.
Using
10