How To Attach The Headsupport In Supine - Leckey Horizon Bedienungsanleitung

7.3 How to attach
the sandals
Each sandal is attached to the hinged
footplate individually with a single fixing bolt.
Remove the sandals from their packaging
and unscrew the plastic knob and washers.
Place the sandal on the footplate locating
the fixing bolt through the slot, place the
rubber washer on first and then the
metal washer. Secure in place with
the plastic knob.
You can flip up the footplate for
easier access.
Always use caution when making this
adjustment, as fingers could become
trapped in the slot while positioning.
7.4 How to attach the
headsupport in Supine
To attach and height adjust, slide the
square tubing into the top of the central spine on
the backrest. To lock the head support push the
over centre lever (a) down until it touches the metal
spine. To remove simply reverse this process. The
Whitmyer Pro-Series range of headsupports can
also be attached to the frame as detailed above.
After use locking lever may need to be fine tuned
to ensure secure locking. To do this lift up the lever
and turn the nut (b) while holding the lever in a
fixed position. Push the lever back down to check
if it locks the tube securely. Repeat the process as
necessary.
Always use caution when making
this adjustment, as fingers could
become trapped in the receiving tube
while positioning.
a
a
b