Assembly; Assembly Conditions - Crivit SL-1530 Bedienungsanleitung

Assembly

Assembly conditions

• Never set up the product higher than
50cm, at a maximum one hand width
below the step. Setup at knee height
recommended.
• The balance band must be suspended
horizontally and tightly tensioned. The
more the band sags, the more difficult
it is to balance.
• Never assemble the product over hard
surfaces such as tarmac or paved sur-
faces. Risk of injury. Always assemble
the product over soft surfaces such as
grass or sand.
• Keep an area of 2 metres to each side
of the product clear of any objects
(e.g. stones or roots).
• Firmly anchored posts or trees are
suitable for securing the product. The
maximum distance between the an-
choring points is 12 metres. The trees/
posts must have a circumference of
one metre at the attachment height.
The attachment points must be able to
withstand at least 25kN.
• Use the tree skin to protect the tree
bark.
• Use an edge guard when assembling
the product between square posts.
• Only tension the slackline by hand.
Never use extensions or other tools.
• Never use the slackline between cars
or other tools, as the initial load can
then become uncontrollable.
6 GB/IE
1.) Tree skin
1 . Always attach one tree skin to both trees with
hook and loop fastener .
2.) Balance band and ratchet
1 . Place the balance band flat around the first
tree and feed through the retaining screw . Fold
the balance band at the middle so it will not
twist when it is later tensioned .
2 . Without twisting, place the ratchet around the
second tree and feed it through the retaining
screw . Make sure that ratchet points down-
wards . Fold the band at the middle so it will
not twist when it is later tensioned .