Switching On/Off And Setting Temperatures; Switching On The Appliance; Setting The Temperature; Switching Off The Appliance - Siemens KS 40 U 640 Gebrauchsanleitung

en
Switching ON and setting temperatures
2
Fig.
Put the plug in the socket.
When the buttons are pressed, an
acknowledgement signal is emitted.
Press the appliance main switch 1.
Warning signal is emitted, refrigerator
temperature display (4 °C) 4 and "Alarm"
display 8 illuminate. "AL" (Alarm) 7
flashes.
Press "alarm" button 11.
Press the Alarm Off button 11. Warning
signal stops and the "warmest
temperature" is indicated on display 7 for
5 seconds. "AL" 7 stops flashing. The
appliance is now running.
Set the temperature for the freezer
compartment.
Repeatedly press or hold down the
selection button 9 until the required
temperature is displayed. The value last
selected is saved. (The temperature
selection is displayed consecutively from
-16 °C to –26 °C. –16 °C is redisplayed
after –26 °C).
We recommend setting the temperature
of the freezer compartment at -20
Note
"AL" is indicated on display 7 if the freezer
compartment is too warm caused by a
power failure or a fault. The freezer
compartment temperature can be selected
by pressing the selection button 9. The
selected temperature is indicated for 5
seconds on display 7. "AL" is then
redisplayed. The selected temperature is
indicated on display 7 as soon as the freezer
compartment has reached the selected
temperature.
Set the temperature for the refrigerator
compartment.
Press the selection button 3 repeatedly or
continuously until the desired temperature
is displayed. The value last selected is
stored. (The temperature selection is
26
displayed continuously from 8
8 0 C is redisplayed after 2
We recommend setting the temperature
of the refrigerator compartment at 4
Note
The temperature in the refrigerator
compartment may fluctuate because:
– The appliance door is opened frequently
– Large quantities of fresh food are placed
in the refrigerator compartment and/or
freezer compartment
– The ambient temperature changes
– The temperature-selector setting for the
freezer compartment changes or
"super" freeze has been activated.
To prevent condensation in the area of
the door seal, the sides of the housing
are partially heated.
If you cannot open the freezer
compartment door immediately after
closing it, wait 2-3 minutes until the
partial vacuum has equalised.
Switching OFF
0 C.
To switch OFF the appliance, press the main
switch, Figure
Longer periods of disuse
If the appliance is not to be used for a
prolonged period:
Press the main switch, Fig.
appliance and leave the doors open.
0 C to 2
0 C).
0
2
/1.
2
/1, clean the
0 C.
C.