Installation
♦
If necessary secure your device against theft with additional measures.
Attach the securing screw with the anchoring plate
material to the engine fi rewall of the vehicle.
IMPORTANT
Possible damage to the cable!
►
Observe the position of the cable when sliding the device into the duct so
as to avoid damaging it.
♦
Carefully push the device into the mounting duct until it locks into place.
♦
After all connections have been made activate the RESET button with a ball
point pen or other pointed object.
♦
Attach the face plate as described under "Installing the face plate".
♦
Finally put on the bezel frame.
Uninstalling the device
To remove the installed device proceed as follows:
♦
Remove the bezel frame
♦
Insert the right and left keys
device. (The tabs are now bent back.)
♦
Pull the device out.
SAB 160 A1
.
47
into their respective slots on the sides of the
49
and the securing
50
GB
13