Description; Technical Data; Putting Into Operation; Equipotential Bonding - Weller WSP 150 Betriebsanleitung

1. Description

The WSP150 soldering iron was specially developed for soldering tasks with extremely high
heat requirements. The 150 W heater power combined with the optimal transfer of heat to
the soldering iron bit guarantee the high performance capability of the soldering iron. Using
an integrated equipotential bonding wire, it is possible to equipotentially bond the soldering
iron bit as required. The anti-static design of the handle and cable comply with the
requirements for electrostatic sensitive device safety.

Technical Data

Supply Voltage : 24 V
Power : 150 W
Warm-Up Time : approx. 45 sec. (50 ºC - 350 ºC)
Max. Temperature : 550 ºC

2. Putting into Operation

Place the soldering iron in the stand. Remove all flammable substances from the area around
the soldering iron. Plug the connector (1) into the supply unit and lock. Set the required
temperature on the supply unit. At the end of the necessary warm-up time, tin the soldering
iron bit with some solder.

3. Equipotential Bonding

If required, the soldering iron bit can be equipotentially bonded via the supply unit used. The
possible ways of connecting the equipotential bonding wire are described in the operating
instructions for the supply unit.

4. Instructions for Use

Bit Changing
- Hold the soldering iron with the bit slightly downwards.
- Undo the knurled bit retaining nut (2).
- The soldering iron bit is now loose in the knurled nut.
WSP150_0.301 7
Caution: The soldering iron bit is hot!
GB
Always place the soldering iron in the stand when not in use.
Anti-static plastics are treated with conductive material to prevent static charging. This results
in a reduction in the insulating properties of the plastic. It is not permitted to work on live
parts.
The operating instructions for the supply unit used are also applicable in addition to these
operating instructions.

5. Accessories

See page 10
03.06.2002, 8:41 Uhr
7