Viking MF 860 Gebrauchsanweisung Seite 18

EN
11. POWER TAKE-OFF (MF 890 PRO)
Switch for engaging/disengaging the electromag-
netic power take-off for operating front-mounted
accessories. Two positions:
1. Press the front part of the switch – the
power take-off is engaged. The symbol
will light up.
2. Press the rear part of the switch – the
power take-off is disengaged.
12. DIFFERENTIAL INHIBITOR
(MF 890 PRO)
Lever for engaging the differential inhibitor. This
improves the towing capacity by locking the rear
wheels so that both wheels drive simultaneously.
Two positions:
1. Forward position – the differential in-
hibitor is not engaged. For normal opera-
tion.
2. Lever in backward position - differen-
tial inhibitor engaged. Works for both for-
ward and reverse drive.
The differential inhibitor is of greatest use when
the rear wheels are unevenly loaded. For example
when turning sharp corners where the inner rear
wheel bears a lesser load.
When driving during the winter on slippery surfac-
es, the drive capacity is improved if snow chains
are not used.
When the differential inhibitor is engaged, the
steering is heavy. Avoid turning the steering
wheel!
13. HOUR COUNTER
Indicates the number of working hours. Only
works when the engine is running.
14. CRUISE CONTROL
(MF 880, MF 890 PRO)
A switch for activating the cruise control. The
cruise control allows the drive pedal to be locked
in the desired position.
18
ENGLISH
1. Press down the drive pedal until the de-
sired speed is obtained. Then press the
front part of the switch to activate the
cruise control. The symbol will light up.
2. Disengage the cruise control by braking
or pressing the rear part of the switch.
15. CUTTING HEIGHT ADJUSTMENT
The machine is equipped with a control for using
the cutting deck with electrical cutting height ad-
justment (available as an accessory).
The switch is used to adjust the cutting
height in continuously variable positions.
The contact used for connecting the cutting deck is
mounted on the right side, in front of the front
wheel (fig. 3).
16. REAR RAKE (MF 890 PRO)
The machine is fitted with a control for electrical
adjustment of a rear rake (available as an accesso-
ry).
The switch is used to raise and lower the
rear rake.
Cables for connecting the rear rake are found at the
rear of the machine, to the left of the upper side of
the bumper.
17. SAND SPREADER (MF 890 PRO)
The machine has been designed for electrical ad-
justment of a sand spreader (available as an acces-
sory).
The switch is used to start and stop the
12V
spreader.
The contact for connecting the sand spreader is
found at the rear of the machine, to the left of the
upper side of the bumper.
18. DISENGAGING LEVER
A lever for disengaging the variable transmission.
Enables the machine to be moved by hand without
the help of the engine. Two positions:
1. Lever moved back – transmis-
sion engaged for normal opera-
tion.
2. Lever moved forward – trans-
mission disengaged. The ma-
chine can be moved by hand.