Reely Audi R8 Bedienungsanleitung Seite 52

Switching Reverse On/Off
• Press and hold the setup button; until the blue LED comes on. After they are lit, release the setup button. The blue
LED flashes (setting mode for reverse).
• You can switch the reverse mode on or off by briefly pressing the setup button. The flash rhythm of the blue LED
changes.
Flash 1x
Function Reverse mode is turned off.
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
Setting the Brake Performance
As with nearly all other control units, the direct movement of the speed / brake lever on the remote control from
forwards to reverse mode activates the brake. However this control unit allows you to adjust the brake performance to
your requirements. Proceed as follows:
• Press and hold the setup button, until the blue and green LEDs come on. After they are lit, release the setup button.
The blue and green LEDs flash (setting mode for brake performance).
• You can select the brake performance by briefly pressing the setup button. The flash rhythm of both LEDs changes.
Flash
Brake performance
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
1x 2x 3x
10% 20% 30%
2x
Reverse mode turned off.
4x 5x 6x
40% 45% 50%
7x 8x 9x
55% 60% 65%
10x
70%
51