Remote Control Connection - Lincoln Electric INVERTEC V270 Bedienungsanleitung

TIG Welding (GTAW)
This machine does not include a TIG torch necessary for
TIG welding, but one may be purchased separately.
Refer to the accessories section for more information.
Most TIG welding is done with DC(-) polarity; connect
the torch cable to the (-) terminal of the machine and the
work clamp to the (+) terminal. Insert the connector with
the key lining up with the keyway and rotate
approximately ¼ turn clockwise. Do not over tighten.
For "V -S" machine, connect the gas hose from the
###
TIG torch to a gas regulator on the cylinder of gas to be
used.
For "V -T / -TP" machine,
###
connect the gas hose from
the TIG torch to the gas
connector (B) on the front of
the machine. If necessary,
an extra gas connector for the fitting on the front of the
machine is included in the package. Next, connect the
fitting on the back of the machine to a gas regulator on
the cylinder of gas to be used. An input gas line and the
required fittings are also included in the package.
Connect the TIG torch trigger to the trigger connector (A)
on the front of the machine.

Remote Control Connection

Refer to the accessories section for a list of remote
controls. If a remote control is used, it will be connected
to the remote connector (C) on the front of the machine.
The machine will automatically detect the remote control,
turn on the REMOTE LED, and switch to remote control
mode. More information on this mode of operation will
be given in the next section.
Controls and Operational Features
Arc Striking Machine Usage Information
(ASG machines only)
The EN 60974-3 Standard specifies that the "ASG"
equipment is intended to be used with mechanically
guided torch.
A. Power Switch: Controls the input
power to the machine. Make
sure the machine is properly
connected to the input supply
before turning the machine on.
B. Fan: The cooling fan will turn
ON when the machine is turned
ON and it will continue to run
whenever the output of the
machine is ON. If the output of
the machine is OFF for more
than five minutes, the fan will
turn OFF. This reduces the amount of dirt that is
deposited inside the machine and reduces power
consumption. Refer to the Output LED section
below for more information about conditions when
the output of the machine is ON.
If a Coolarc 20 is connected to a "V2
will be turned ON and OFF with the operation of the
fan. When Stick welding mode is used the Coolarc
20 will be OFF.
WARNING
-T / -TP", it
##
If a Coolarc 30 is connected to a "V405-T / -TP", it
will be turned ON and OFF with the operation of the
fan. When Stick welding mode is used the Coolarc
30 will be OFF.
C. Gas Inlet (V
###
shielding gas. Use the supplied gas line and
connector to connect the machine to the gas
source. The gas source must have a pressure
regulator and flow gage installed.
D. Mode Switch: This switch changes the welding
modes of the machine. The "V
welding modes: Stick (SMAW) and Lift TIG (GTAW).
The "V -T / -TP" machines have three welding
###
modes: Stick (SMAW), Lift TIG (GTAW) and HF TIG
(GTAW).
When the mode switch is in the Stick position, the
following welding features are enabled:
A-3
-T / -TP only): Connector for the TIG
-S" has two
###