Metrohm 751 GPD Titrino Gebrauchsanweisung Seite 169

751 GPD Titrino
SmplData.ONSilo.EditLine.1.Mark
etc., up to .255
Contents of a silo line.
.Method: Method used to process the sample, from the method memory or
from the card.
.Id: The identifications Id1...Id3 can also be used as sample-specific
calculation constants C21...C23 in formulas.
.UnitSmpl: If "no unit" is desired for the sample size, the blank string must be
entered.
.C24, .C25: Results which have been assigned to C24 and C25.
.Mark: Mark of the silo line: "*"=deleted line, "+"=line which is worked
off, "-"= line which is worked off and not valid for silo calcula-
tions (deleted), "/" last worked-off line, where recalculation can
still be done. Silo lines which have been worked off are "read
only".
3.2.2.125. SmplData.ONSilo.DelLine
SmplData.ONSilo.DelLine.LineNum
Deletion of a silo line. The line # is deleted with &SmplData.ONSilo.DelLine
$G. If a formerly deleted line is edited again, it becomes valid (function "unde-
lete").
3.2.2.126. SmplData.ONSilo.DelAll
Deletes the entire silo memory. Must be triggered with $G.
3.2.2.127. SmplData.ONSilo.CycleLines
Silo data cycling.
With "ON", executed lines are copied to the next free silo lines, see page 96.
Exercise caution if you edit the silo memory during the determinations!
3.2.2.128. SmplData.ONSilo.SaveLines
Silo lines are not deleted when they are worked off. Assigned results are
stored as C24 and C25. "Save lines" can only be set to "ON" if the silo is
completely empty. Delete the silo, see 3.2.2.126.
3.2.2.129. HotKey.User.Name
HotKey.User.Delete
HotKey.User.Delete.Name
HotKey.User.DelAll
HotKey.User.List.1.Name
Management of user names.
.Name: Input of user names.
.Delete.Name: Deletes selected user name with &HotKey.User.Delete $G.
.List: List of all user names.
3.2.2.130. Info.Report
Info.Report.Select
3.2 Remote control commands
up to 10 ASCII characters
up to 10 ASCII characters
configuration, parameters, smpl data,
read only
$G
1...255, OFF
$G
ON, OFF
ON, OFF
$G
$G
read only
$G
165