Metrohm 751 GPD Titrino Gebrauchsanweisung Seite 161

751 GPD Titrino
3.2.2.72. Mode.Parameter.Calibration.SmplChanger
Parameters for CAL: Calibration at Titrino.
With "ON", there are no hold points in the calibration sequence for entries, the
first buffer is measured directly.
3.2.2.73. Mode.Parameter.Calibration.ActPulse
Parameters for CAL: Output of a pulse on the I/O line "Activate", see page
224.
3.2.2.74. Mode.Parameter.Sequence.X.Select
Parameters for TIP: Selection of an element for step X (X = 1...30). For the
parameters of the elements see 3.2.2.75.
3.2.2.75. Mode.Parameter.Sequence.X.Method
Mode.Parameter.Sequence.X.Pause
Mode.Parameter.Sequence.X.L4Output
Mode.Parameter.Sequence.X.L6Output
Mode.Parameter.Sequence.X.Info
Mode.Parameter.Sequence.X.Prep
Mode.Parameter.Sequence.X.Stirrer
Parameters for TIP: Parameters of the elements of TIP.
.Method: Method name of a method available in the user memory or on the
card. Up to 8 ASCII characters.
.Pause: Pause time in s. INF means infinite. Continue the sequence with
&m $G.
.L4 Output: Warning: A pulse triggered by the limit value monitoring at L4 (pin
3) in a submethod sets an output set to active in TIP to inactive.
.L6 Output: Warning: An activate pulse at L6 output (pin 1) in a submethod
sets an output set to active in TIP to inactive.
.Info: Entry of a message which is written into the display. The se-
quence remains in the display with the corresponding message.
Continue with &m $G.
.Prep: Preparation of titrating burette.
.Stirrer: Switching stirrer on/off.
3.2.2.76. Mode.Parameter.Presel.MeasMode
Mode.Parameter.Presel.MeasInput
Mode.Parameter.Presel.Ipol
Mode.Parameter.Presel.Upol
Mode.Parameter.Presel.PolElectrTest
Mode.Parameter.Presel.Temp
Parameters for TIP: Selection of the measured quantity for manual measure-
ments in the inactive state, see 3.2.2.2. Selection of the measuring input
3.2 Remote control commands
first, all, OFF
method, pause, L4 output,
L6 output, info, prep, stirrer, OFF
Method name
0...999 999, INF
active, inactive,
up to 16 ASCII characters
internal D0, external D1,
pH, U, Ipol, Upol, OFF
0...400...±1270
-170....25.0...500.0
ON, OFF
pulse, OFF
as for L4
external D2
ON, OFF
1, 2, diff.
0...1...±127
ON, OFF
157