C) Preparing And Assembling The Aileron Linkage - Reely SKY Islander Bedienungsanleitung

c) Preparing and Assembling the Aileron Linkage

Elongate the control line for the aileron servo (1) by approx. 250 mm to be able
to later insert it into the wing.
Use the included thread to pull the servo cable through the cable duct to the
centre of the wing and use two screws (2) to attach the servo to the wing.
Install the descent lever (3) so that it points towards the wing tip.
Attention!
Make sure that the servo is in neutral position before screwing it
into the wing.
Our advice: To prevent the plug connection from getting loose, use heat-shrink
tube or adhesive tape.
Set the aileron linkage rods (1) to a length of 110 mm. Hook the bent linkage
rod of the servo descent lever (2) and the clevis (3) into the aileron rudder horn.
Secure the clevis by pushing on the rubber hull (4).
Figure 6a
Figure 6b
31