B) Motor-Modelvliegtuigen - ModelCraft WFT 09 Bedienungsanleitung

b) Motor-modelvliegtuigen

Functie-instelmenu (NORMAL SETTING) voor motor-modelvliegtuigen:
1 Servo-aansturing .......................................................... (MONITOR)
2 Dualrate-/exponential-functie ....................................... (DUALRATE & EXPONENTIAL SETTING)
3 Servo-looprichting omschakelen ................................. (SERVO REVERSE)
4 Servo-einduitslag ......................................................... (END POINT)
5 Sub-trimming ................................................................ (SUBTRIM)
6 Kanaaltoewijzing .......................................................... (AUXILIARY CHANNELS SETTING)
7 Gascurve-instelling ....................................................... (THROTTLE CURVE SETTING)
8 Trimsnelheid ................................................................. (TRIM STEP SETTING)
9 Flaperon-functie ........................................................... (FLAPERON)
10 Kleppen-instelling ......................................................... (FLAP TRIM)
11 Rolroer-differentiëring .................................................. (AIL-DIF)
12 Hoogteroer-kleppenmenger ......................................... (ELEV-FLAP)
13 Motor uitschakeling ...................................................... (THROTTLE CUT SETTING)
14 Motortoerental verlaging .............................................. (IDLE DOWN)
15 Failsafe-instelling ......................................................... (FAIL SAFE)
16 Timerinstelling .............................................................. (TIMER)
17 Uitgebreid functiemenu ................................................ (ADVANCED)
18 Taalinstelling ................................................................. (LANGUAGE)
Uitgebreid functie-instelmenu (ADVANCED) voor motor-modelvliegtuigen:
1 Curve-instelling ............................................................ (CURVE SETTING)
2 Programmeerbare lineaire menger .............................. (PROG.NOR.MIX1 - PROG.NOR.MIX7)
3 Programmeerbare curve menger ................................ (PROG.CUR.MIX1 - PROG.CUR.MIX4)
4 Remfunctie ................................................................... (AIR BRAKE)
5 Hoogteroer-dwarsroer menger .................................... (ELEVON)
6 Rolroer-hoogteroer menger ......................................... (AILVATOR)
7 V-sturing menger .......................................................... (V-TAIL)
8 Snaprol-functie ............................................................. (SNAP-ROLL)
9 Gas-vertraging ............................................................. (DELAY)
10 Mengsel-instelling ........................................................ (THROTTLE NEEDLE MIXING)
11 Gyroscoop-gevoeligheid .............................................. (GYRO SENS SETTING)
84