B) Motor Model Planes - ModelCraft WFT 09 Bedienungsanleitung

b) Motor model planes

Function menu („NORMAL SETTING") for all motor model planes:
1 Servo control ................................................................ („MONITOR")
2 Dual rate/exponential function ..................................... („DUALRATE & EXPONENTIAL SETTING")
3 Servo reverse ............................................................... („SERVO REVERSE")
4 Servo end point ............................................................ („END POINT")
5 Sub trim ........................................................................ („SUBTRIM")
6 Channel assignment .................................................... („AUXILIARY CHANNELS SETTING")
7 Throttle curve setting ................................................... („THROTTLE CURVE SETTING")
8 Trim step ....................................................................... („TRIM STEP SETTING")
9 Flaperon function ......................................................... („FLAPERON")
10 Flap trim ....................................................................... („FLAP TRIM")
11 Aileron differentiation ................................................... („AIL-DIF")
12 Elevator-flap mixer ....................................................... („ELEV-FLAP")
13 Motor cut-off ................................................................. („THROTTLE CUT SETTING")
14 Idle down ...................................................................... („IDLE DOWN")
15 Fail-safe settings .......................................................... („FAIL SAFE")
16 Timer settings ............................................................... („TIMER")
17 Advanced function menu ............................................. („ADVANCED")
18 Language selection ...................................................... („LANGUAGE")
Advanced function menu („ADVANCED") for model motor planes:
1 Curve setting ................................................................ („CURVE SETTING")
2 Programmable linear mixer .......................................... („PROG.NOR.MIX1 - PROG.NOR.MIX7")
3 Programmable curve mixer .......................................... („PROG.NOR.MIX1 - PROG.NOR.MIX7")
4 Brake function .............................................................. („AIR BRAKE")
5 Elevator-aileron mixer .................................................. („ELEVON")
6 Aileron-elevator mixer .................................................. („AILVATOR")
7 V-tail mixer .................................................................... („V-TAIL")
8 Snap-roll function ......................................................... („SNAP-ROLL")
9 Throttle delay ............................................................... („DELAY")
10 Mixture adjustment ....................................................... („THROTTLE NEEDLE MIXING")
11 Gyro sensitivity ............................................................. („GYRO SENS SETTING")
40