Mettler Toledo IND226 Bedienungsanleitung Seite 29

F1.5.4 – Auto tare threshold
This menu item is only available if F1.5.1=On is set.
The weighing platform must be loaded to the set value before the weight value is automatically
tared.
Factoriy setting
Possible settings
F1.5.5 – Auto clear tare threshold
This menu item is only available if F1.5.1=On is set.
The weighing platform must be unloaded below the set value before a new weight value can
be tared automatically.
If F1.5.2=On is set, the weighing platform must be unloaded to the set value before the tare
value is cleared automatically.
Factory setting
Possible settings
F1.6.1 – Digital filter
The digital filter stabilizes the weight display when the load is moving or vibrating.
Low filter
Lo
Medium filter
MEd
High filter
HIGH
F1.6.2 – Motion detection
Motion detection within +/–0.5 d
0.5 d
Motion detection within +/–1 d
1 d
Motion detection within +/–3 d
3 d
F1.10 – Resetting parameters 1.x(.x) to factory setting
Reset all F1 parameters to factory setting, except for calibration values. In OIML and NTEP
mode the Geo value is not reset.
10 d
0 ... maximum load
10 d
0 ... maximum load
(not available in OIML and NTEP modes)
(not available in OIML and NTEP modes)
29