Rack-Mount Setup - Eaton 9910-P33 Installationsanleitung

Rack-Mount Setup

The UPS can be installed in 19-inch racks and needs only 2U of valuable
rack space.
The UPS and EBM are heavy. A minimum of two people are required to lift the cabinets into
the rack.
NOTE Fixed mounting rails are required for each UPS and EBM cabinet. If fixed rails are
not already installed in your rack, contact your local IBM representative to order a rail kit(s). If
you are installing the UPS in a non-IBM rack, contact your Powerware representative.
To install the UPS in a rack:
1.
2.
3.
NOTE The UPS and EBMs MUST be installed at the bottom of the rack. If placed in a rack
with existing equipment, the rack must be reconfigured to allow the UPS installation at the
bottom of the rack.
NOTE The EBMs must be installed below the UPS as shown in Figure 5.
4.
5.
®
EATON Powerware
Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
Attach the supplied mounting handles to the mounting brackets and
secure with the supplied screws (see Figure 4).
If installing optional EBMs, repeat Steps 1 and 2 for each cabinet.
Figure 4. Installing the Mounting Handles
Slide the UPS and any optional EBMs into the rack.
Secure the units to the rack according to the rail kit instructions.
5125 (9910-P33) UPS Installation Guide for IBM
C A U T I O N
Mounting Handle
® S
Applications 164201634 Rev A
INSTALLATION
Mounting
Bracket
5