Operation; Turning The Ups On; Starting The Ups On Battery - Eaton 9910-P64 Installationsanleitung

Chapter 2

Turning the UPS On

Starting the UPS on Battery

EATON Powerware

Operation

This section describes:
S
Turning the UPS on and off
S
Starting the UPS on battery
S
Initiating the battery test
S
Transferring the UPS to Bypass mode
S
Operating modes
After the UPS is connected to utility power, it enters Standby mode.
To turn on the UPS, press the On button on the front panel (shown in
Figure 34 on page 37). The
graph indicators display the percentage of load being applied to the UPS.
NOTE Before using this feature, the UPS must have been powered by utility power at least
once.
To turn on the UPS without using utility power, press and hold the
On button for approximately three seconds. The UPS supplies power
to your equipment and transfers to Battery mode.
®
9125 (9910-P64) UPS Installation Guide for IBM
μ
indicator illuminates solid and the bar
® S
Applications 164201637 Rev A
35