Assembling The Juicing System - Gastroback DESIGN MULTI JUICER DIGITAL Bedienungsanleitung

Note
When combining the various glass containers and blade assemblies, keep in mind
that the best results will be achieved in most cases, when using the glass contai-
ners with the dedicated blade assembly. In some cases, adapting the processing
time or speed level may be adequate too. Additionally, you may try operation in
pulses.

ASSEMBLING THE JUICING SYSTEM

1. Place the pulp container tightly against the left side of the motor base. The pulp
container protrusion at the baseplate of the motor base must slide completely into
the groove at the bottom of the pulp container.
Important: Ensure that the exterior of the juice collector is clean and dry, before
mounting it on the motor base to avoid that residues of food and liquids get into
the motor base and/or clog the safety interlocks.
2. Place the juice collector on the motor base with the juice spout facing to the
locking arm. Make the juice spout slide into the spout groove and the pulp gut-
tering into the pulp container. Ensure that the drip-stop of the juice spout is turned
to the open position: the dark bar at the stainless steel sleeve of the juice spout
will be facing towards you.
CAUTION:
sieve at the rim.
3. Insert the juicing sieve into the centre of the juice collector and press it down
without violence to lock it to the drive rotor. If required, turn the juicing sieve to
and fro to achieve the correct orientation before pressing it down.
4. With the pulp spout sliding into the pulp container, place the juicer cover onto
the juice collector and press it down slightly without violence until it settles firmly
on the juice collector. There may be no gap between the juicer cover and the
juice collector.
5. Carefully lift the locking arm up to the vertical closed position by pushing the
locking arm onto the support on the juicer cover until it tangibly engages. If atta-
ched correctly, the locking arm will be fixed in this position.
6. Place the juice jug under the juice spout. Then cover the juice jug with the desi-
gnated lid. The appliance is now ready for juicing.
The knives of the juicing sieve are very sharp. Hold the juicing
99