ZyXEL NBG4115 Bedienungsanleitung Seite 145

Click Security > Firewall > Services. The screen appears as shown next.
Figure 75 Security > Firewall > Services l
The following table describes the labels in this screen.
Table 51 Security > Firewall > Services
LABEL
ICMP
Respond to Ping
on
Do not respond
to requests for
unauthorized
services
Apply
Reset
User's Guide
DESCRIPTION
Internet Control Message Protocol is a message control and error-
reporting protocol between a host server and a gateway to the Internet.
ICMP uses Internet Protocol (IP) datagrams, but the messages are
processed by the TCP/IP software and directly apparent to the
application user.
The NBG4115 will not respond to any incoming Ping requests when
Disable is selected. Select LAN to reply to incoming LAN Ping requests.
Select WAN to reply to incoming WAN Ping requests. Otherwise select
LAN & WAN to reply to all incoming LAN and WAN Ping requests.
Select this option to prevent hackers from finding the NBG4115 by
probing for unused ports. If you select this option, the NBG4115 will not
respond to port request(s) for unused ports, thus leaving the unused
ports and the NBG4115 unseen. By default this option is not selected
and the NBG4115 will reply with an ICMP Port Unreachable packet for a
port probe on its unused UDP ports, and a TCP Reset packet for a port
probe on its unused TCP ports.
Note that the probing packets must first traverse the NBG4115's firewall
mechanism before reaching this anti-probing mechanism. Therefore if
the firewall mechanism blocks a probing packet, the NBG4115 reacts
based on the firewall policy, which by default, is to send a TCP reset
packet for a blocked TCP packet. You can use the command "sys firewall
tcprst rst [on|off]" to change this policy. When the firewall mechanism
blocks a UDP packet, it drops the packet without sending a response
packet.
Click Apply to save the settings.
Click Reset to start configuring this screen again.
Chapter 13 Firewall
145