Connecting The Inputs; Connecting The Outputs - MC Crypt DJ-70 Bedienungsanleitung

Connection
a) Connecting the inputs
LN-2 and LN-4 inputs:
There are two stereo cinch inputs available to which you can connect your reproduction devices, e.g. radio, CD player
or MP3 player. These inputs are suitable for connecting audio devices with line level.
The inputs are not suitable for record players.
LN-1/PH-1 and LN-3/PH-2 inputs:
These inputs are variable inputs which can be influenced by their respective switches INPUT SELECT (23 and 25).
Depending on the switch position, these inputs can be used to connect a record player or a CD player (or similar line
device).
Prior to connection, check the position of the respective switch INPUT SELECT (23 or 25). Set
the switch to the right position. Before switching over, always switch off the mixer at the
POWER switch (6).
LN switch position:
PH switch position:
Connection DJ MIC (1)
You can connect your microphone to this input.
b) Connecting the outputs
OUTPUT AMP (27)
Connect the AMP output to a free cinch input of your amplifier (e.g. AUX).
OUTPUT REC output (27)
If you wish to record the output signal from the mixing desk using a recording device, connect the recording input of
the device to the REC jacks (27) on the mixing desk.
PHONES headphone jack (11)
Connect headphones with a 6.3 mm jack plug to the headphone jack.
32
A device with LINE level can be connected to the respective input, e.g.
CD player, MP3 player, tuner etc.
A record player with magnet system can be connected to the respective input (this
system is used with almost all DJ record players).