Flex Mode; System Configuration (Configure); Setting The Time (Time Setup) - Silvercrest SFB 10.1 C3 Bedienungsanleitung

SilverCrest SFB 10.1 C3

Flex mode

For the different device buttons there are preset code lists for specific
device groups. Normally, you will assign the corresponding device types
to the device buttons. For example, you will assign programming a VCR
to the device button, a DVD player to the
etc. Furthermore, the Flex mode conveniently lets you assign a device
from any device group to the
that you assign the code list of the desired device group (where the
device belongs to) to the
this device.
The code lists (e.g. 0 for TV or 2 for DVD) belonging to each device
group can be found in the table below:
TV VCR
0 1
For direct code input:
1. Press and hold the
2. Press
3. Press
4. Then press the device button
program and press
5. The first digit of the 4-digit device code currently set flashes.
6. Enter the correct 4-digit code for the selected device using the
number buttons, then enter the number of the corresponding code list
(0 to 7) and press
7. Press
followed by "CODE SET".
8. Invalid CODES cannot be found in the CODE list. If you enter an
invalid code "NOT FOUND" appears on the display and you can
then enter the correct code.
Press to go back one menu level. To return to the start window,
press one of the device buttons. On the left of the time the code assigned
to the device button
selected code list (0 to 7) is also displayed to the left of the day of the
week.
Before you can program the device buttons
brand code search or automatic search, it is necessary to assign the code
list to the device button. To do so, proceed as described in the previous
section, select the number 0001 as your code and select the number of
the desired code list (0 to 7). This assigns the code list to the device
button
At this point, programming the device buttons
the same way as described in the "Automatic code search (AUTO
SRCH)" and "Brand code search (BRAND SRCH)" chapters.

System configuration (CONFIGURE)

Setting the time (TIME SETUP)

1. Press and hold the
2. Press
3. Press
16 - English
DVD DSAT
2
, select "CODE SETUP" and press
, select "CODE SET" and press
to confirm.
to confirm.
to confirm the entry. The display reads "SUCCESS"
or so you can proceed with programming.
, select "CONFIGURE" and press
, select "TIME SETUP" and press
and
or
BD
3 4
button for 3 seconds.
or
or is shown on the display. The
button for 3 seconds.
device button,
buttons. The requisite is
button you want to use for
AMP CBL
5 6
to confirm.
that you wish to
or
or
CD
7
to confirm.
using the
works
to confirm.
to confirm.