Unold 68801 Bedienungsanleitung Seite 18

6. Place the kneader cover on the axle. Here
again, the notch must align with the corres-
ponding guide rail. The flat side of the knea-
der cover must point to the back (Fig. 4).
7. Push the entire feed screw axle assembly
through the front cover of the mixing con-
tainer. The threads must point toward the
outside (Fig. 5).
8. Lock the front cover of the mixing container.
The symbol  must align with the arrow on
the mixing container. Then turn clockwise
until the arrow aligns with the symbol 
(Fig. 6).
9. Important: the front cover must be correctly
locked and secured before you continue
assembling the appliance. If the lid is already
on the mixing container, the front cover cannot
be locked.
10. Then push the entire front unit onto the
motor block.
11. The axle of the mixing unit must be inserted
into the hole on the front side of the motor
block. The two recesses and the bottom
holes in the mixing unit must correspond
exactly with the motor block (Fig. 7).
12. Hold the lid upright on the mixing container
and make sure that the two projections on
the lid fit into the recesses on the front side
of the motor block. Press the lid down until
it locks into place on the mixing container
(Fig. 8).
13. Important: The sealing cover must audibly
lock into place, since this activates the
safety switch; otherwise, the appliance
cannot be switched on. In case the cover
does not lock into place, check whether the
mixing container was inserted correctly.
18
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8