Connecting The Camera; Maintenance And Cleaning; Technical Data - Conrad 75 18 02 Bedienungsanleitung

Connecting the Camera

• Connect the low voltage plug of the camera with the extra-low voltage plug of a sta-
bilised power supply unit.
Only a 12 V/DC stabilised wall-plug transformer may be used, which
provides at least 250 mA (recommended = 300mA). Polarity:
plus=inside, minus=outside
• Connect the BNC video connector of the camera to the video input on your display
(e.g. monitor).
Start-up
• Make sure the power supply unit is connected to the camera.
• Plug the transformer into a mains socket.
• Switch on your display unit.
• Select the appropriate channel on your display to obtain a picture.
Always pay attention to the operating instructions for your display
unit, as well.

Maintenance and Cleaning

To clean the outside of the camera, it is sufficient to use a dry, soft and clean cloth. If
it is very dirty, the cloth can be moistened slightly.
Clean the camera housing very carefully, otherwise you may scratch it. Do not use
any aggressive cleaning agents.
Disposal
Electrical and electronic products do not belong in the household waste!
Please dispose of the device, when it is no longer of use, according
to the current statutory requirements.

Technical Data

Operating voltage:
Current consumption:
Recommended power transformer: 12 V/DC, 300 mA
Camera lens:
Image sensor:
TV lines:
Detection area, horizontal:
Detection angle, vertical:
Operating temperature:
Light sensitivity:
IR-LEDs:
IR LED range:
IP protection class:
Video output:
Weight:
Dimensions (Ø x D):
12 V/DC
max. 250 mA
Plug polarity (inside=plus, outside=minus)
6 mm
8.5 mm (1/3") Sony Super HAD CCD
420
45°
35°
-10° to +50°
1 LUX (without IR-LEDs), 0 LUX (with IR-LEDs)
24
max. 20 metres
IP65
connection = BNC (75 Ohm, 1 Vss)
approx. 354 grams
93 x 67 mm
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.