Golden Media Hypercube Bedienungsanleitung Seite 31

For Ports A, B, C and D select the desired satellites just as described in the Single satellite – direct connection
section.
Make sure you know which satellite is connected to which input on the Tone-burst switch.
If you do not find any services in the transponder scan later, exchange the two satellites in this list and try again.
Press the OK-Button to save your settings.
12.1.5 Tuner B setup (DVB-S/DVB-S2)
The same setup possibilities that applied for Tuner A also apply
for Tuner B. There are some additional configuration options.
Equal to socket A:
Use this setting if Tuner B should use the same settings as Tuner
A.
Loop through to socket A:
Use this option if the LNB1 out should be connected to the LNB2
in. You do not need an external connection cable.
If no OSD menu is visible on your screen, press the Menu-Button
to open the main OSD menu. Navigate to the option "Setup" and
press the OK-Button to select.
1. Navigate to the option "Service searching" and press the
OK-Button. The "Service searching" menu will open up
2. Navigate to the option "Tuner configuration" and press the
OK-Button. The "Choose tuner" menu will open up.
3. Use the Navigation-Buttons up and down to select the DVB-T Tuner and press the OK-Button. The
"Reception settings" menu will open up.
Choose your region by pressing the Navigation-Buttons left/right.
If you have connected an active antenna and you want to run the
antenna without it's original power supply set the "Enable 5V for
active antenna" option to "On".
Press the OK-Button to save your settings.
If no OSD menu is visible on your screen, press the Menu-Button
31