Master-Slave Mode; Automatic Operation; E) Sound-To-Light Mode - Renkforce S1 Bedienungsanleitung

c) Master-Slave mode
• Select SLMd in the menu.
• Push the button ENTER (6) and select the desired operating mode with the buttons UP (5) and DOWN (4).
• Set the menu MASt to define the device as a master (control via the installed controller).
• Set the menu SL 1 to define the device as a slave (control via the controller of the connected master
device).
• Press the ENTER button (6) to confirm your input.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
d) Automatic operation
In automatic mode, the device works according to the command sequence pre-programmed in the factory.
• Select SHMd in the menu.
• Push the button ENTER (6) and select the desired automatic programme SH 1-SH 8 with the buttons UP
(5) and DOWN (4).
• Press the ENTER button (6) to confirm your input.

e) Sound-to-Light mode

In Sound-to-Light mode, the moving head reacts to the music signals that are detected by the integrated
microphone MIC (2). This causes the moving head to generate a light show in time to the music.
• Select Soun in the menu.
• Push the button ENTER (6) and select on or oFF with the buttons UP (5) and DOWN (4).
oFF = Sound-to-light mode deactivated
on = Sound-to-light mode activated
• Press the ENTER button (6) to confirm your input.
The sensitivity of the microphone MIC (2) can be set with the small setting controller below the
microphone and thus adjusted to the music volume. Set the controller so that the light effect
changes in time with the music.
36