Connecting The Battery Charger - Dometic TEC29 Montageanleitung

Connecting the electrical power to the generator
10.3 Connecting 230 V
NOTICE!
A
 Connect a relay or a switch to the vehicle's electrical system
(see "Accessories" on page 37) so that the generator is not
damaged when the power supply is switched on.
 Ensure that the electrical system is set up as follows:
– TNS network:
The neutral conductor must be linked to the PE conductor on
the terminal via a jumper with a minimum diameter of
2.5 mm
that a safety switch (FI switch, 30 mA) and an in all-pole
overcurrent protection (e.g. circuit breaker, 13 A) are in-
stalled.
– IT network:
Ensure that an insulation monitor and an in all-pole overcur-
rent protection (e.g. circuit breaker, 13 A) are installed.
 Connect the generator so that it takes priority over the power
supply.
➤ Guide the 230 V connection cable through the cable passage in the hous-
ing and connect it to the 230 V terminals (for TEC29: fig. e 7, page 9, for
TEC29LPG: fig. f 6, page 9).
➤ Connect the earth cable to the earth connection on (fig. e 6, page 9, for
TEC29LPG: fig. f 7, page 9).
10.4

Connecting the battery charger

➤ Connect the positive terminal of the battery with the 12 V connection of
the battery charger using a cable with a cross-section of 2.5 mm² (for
TEC29: fig. e 5, page 9, for TEC29LPG: fig. f 8, page 9).
➤ If the battery to be charged is not also the starter battery, connect the neg-
ative terminal of the battery to be charged to the generator's earth cable
(fig. g 1, page 10).
46
2
. To protect against automatic shutdown, make sure
TEC29, TEC29LPG
EN