Marmitek GSM GUARD 300 Betriebsanleitung Seite 7

Step 6 Connecting the siren
Figure 6
Standard, a siren is included. You can connect the siren directly to the GSM Guard 300
Module. The connection diagram can be found on the back of the GSM Guard 300. See fig-
ure 6. Connect the red wire to the + port and the black wire to the– port. You can mount the
siren in the right place using two screws (not included).
If you do not connect the siren, select Buzzer off in the Setup mode (also see step 8.2).
TIP: Instead of a siren, you can also connect X10 modules, e.g. the SM10, which can switch
on equipment, lights or a camera via the mains (also X10 connected) when the alarm is trig-
gered. Read more about X10, the many possibilities to control devices remotely and Marmitek
surveillance cameras on www.marmitek.com.
Step 7 Connecting a lamp (optional)
The Marmitek GSM Guard 300 has a built-in relay. This offers you the opportunity to connect
e.g. a lamp, which can be switched on and off via the text (SMS) commands
RELAY-ON, RELAY-OFF and CONTROL. The connection diagram can be found on the back of
the GSM Guard 300. Connect the wires to the respective ports on the back of the GSM
Guard 300.
TIP: Instead of a lamp you can also connect X10 modules, e.g. the SM10, which can switch
on equipment, lights or a camera via the mains (also X10 connected) when the alarm is trig-
gered. Read more about X10, the many possibilities to control devices remotely and Marmitek
surveillance cameras on www.marmitek.com.
GSM GUARD 300 7