Skil 0805 Originalbetriebsanleitung Seite 5

Submersible pump
(clean/dirty water)
INTRODUCTION
• This submersible pump has
been designed for use in private
households only and is primarily
intended for removing water from
flooded areas
• The pump is also suitable for
transferring water to and from
tanks and pumping them out,
for removing water from wells,
shafts, boats, and yachts, as well
as for aerating and circulating
water for limited periods
• The submersible pump for clean
water is suitable for transferring
clean and/or slightly dirty water
with a maximum particle size of
5 mm as well as swimming pool
water and/or soapy water (0805)
• The submersible pump for dirty
water is suitable for transferring
dirty water with a maximum
particle size of 35 mm as well
as swimming pool water and/or
soapy water (0810)
• The pump can be fully
submerged and lowered down
to a depth of 7 metres into the
water
• The pump is not suitable for
0805/0810
• The temperature of the liquid
• Do not use the pump for
• Pollution of the liquid could occur
• Skil cannot be hold responsible
• Read this instruction manual
TECHNICAL DATA 1
TOOL ELEMENTS 2
A Connection elbow
B Universal hose connector
C Carrying handle
D Float switch
E Air bleed valve
F Supply power cable
G Float switch cable
H Cable holder
J Fastening screws (3)
K Suction base
L Cover plate screws (3) (0810)
M Cover plate (0810)
N Rubber ring (0810)
5
continuous pump operation
(as in garden ponds) or as a
stationary installation (as in
outdoor fountains)
transferred may not exceed
35°C
transferring corrosive,
flammable or explosive
substances (such as petrol,
paraffin, petroleum, cellulose
thinners) as well as grease,
oil, salt water and sewage
due to leakage of lubricants
for any damages resulting
from improper use or wrong
operations
carefully before use and save
it for future reference