Completing The Model Plane; A) Attaching The Wing - Reely SKY Piper J3 Cub RtF Bedienungsanleitung


11.

Completing the Model Plane

Before installing the wing on the model, check that the connection cable for the flight battery protrudes from the model
at the bottom (also see figure 8, item 2). If this is not the case, the cable can be pulled out of the model with pincers
from the top through the opening into the wing support at the bottom.

a) Attaching the Wing

Attach the wing (1) onto the top of the fuselage (2) and
push the wing forward to the stop. The holding angle
(3) at the bottom of the wing must interlock with a chute
(4) at the front edge of the wing fuselage opening.
If installed correctly, the rear edge of the wing (5) is
flush with the fuselage and securely held by a solenoid
(6).
Then align the wings so that the triangular fuselage
contour (7) at the rear edge of the wings is flush with
the fuselage. The two lines (A1 and A2) should be
equally long.
Important!
To remove the wing, lift it slightly at the rear
edge and pull off the wing backwards.
If the wing is lifted too far at the rear edge,
the holding angle or wing may be damaged
in the area of the angle.
44
Figure 6