Flybar Set Assembly; Flight Operation; Switching On The Model - Carson SKY EAGLE Betriebsanleitung

l. Flybar Set Assembly
1. Let the location notch of the flybar block aim at the flybar,
and press the flybar block till the flybar reaches the end of
the notch; insert one end of the flybar through the hole 1.
2. Let the location notch of the flybar block aim at the inner
location mast of the flybar block sleeve, and press the flybar
block along the inner location mast into the sleeve.
3. Counterclockwise rotate 90° the flybar block sleeve, let the
hole 1 of the flybar block sleeve aim at the hook of the flybar,
and then push the flybar block set outside and make the
hook completely insert into hole 2.
Please note:
The flybar set will be thrown off at high speed in flying when it
is mounted improperly. This can cause serious injury to people
or damage to objects.
m. Flight Operation

Switching on the model

Ensure sufficient space in order to undertake the first flight
experiments. Even if the helicopter can later be flown in the
smallest quarters, it requires about 3m free space in all
directions.
• Set the model on a smooth and level surface, so that the
helicopter can freely glide and lift off.
• Set the helicopter about 2 m in front of yourself on the
ground, the tail pointing towards you. This way the direction
of reaction of the helicopter conforms to the direction of
control.
• Retract the throttle/pitch control completely.
(also the trim).
• Switch the transmitter on.
• The battery indicator starts to flash.
• Now connect the charged airplane battery to the receiver.
CARSON Helikopter SKY EAGLE 50 070 7042
Flybar block Flybar block sleeve
Flybar
Location notch
Flybar block sleeve
GB
➀
➁
90°
21