Rc Functions Of The Helicopter; Technical Data - Carson SKY EAGLE Betriebsanleitung

b. RC Functions of the Helicopter
GB
The following functions are controlled
with the two remote control levers of
the portable transmitter.
For every control function there is a trim slider on the
remote control transmitter which permits minor
corrections of the neutral position.
Pitch function
(ascend / descend)
The pitch function controls the flying height of this
model helicopter over a common variation in
speed of the two rotors. The control takes place
with the left control lever. To do this, move it
forwards and backwards in a continuously variable
fashion. Contrary to the other control functions this
lever does not spring back into the middle position. If the
control lever is totally drawn towards the back, then the
motors are off and the rotors stand still. If the control lever is
pushed forward then the motor starts running and the rotors
run with increasing speed depending on the lever position.
The helicopter should be in hovering mode with the control
lever in an approximate central position.
Tail function
(Rudder function)
The tail function causes a rotation of the model around the
vertical axis. Since the helicopter has two opposed rotors, no
torque ensues around the vertical axis at the same speed of
the rotors (rotor shaft). The helicopter also therefore requires
no tail rotor for stabilization. In order for the model to be able to
rotate around the vertical axis (rotor shaft), the rotors must run
at slightly different speeds. The resulting torque introduces the
rotation.
At less speed of the steering rotor compared to the bearing
rotor, the torque of the bearing rotor is greater, the helicopter
turns around the vertical axis in the direction of rotation of the
steering rotor. At higher speed of the steering rotor, the torque
of the
bearing rotor is less than that of the steering rotor and the
helicopter turns in the direction of the bearing rotor.
Control of the tail rotor function is by means of the left-hand
control lever. If the lever is moved to the left, the tip of the
fuselage turns to the left. If you move the lever to the right, the
tip of the fuselage likewise turns to the right.

Technical data

Principal rotor diameter A
Principal rotor diameter B
Length
Height
Weight
Battery charger „Lipo Balance"
Input:
Output:
10 CARSON Helikopter SKY EAGLE 50 070 7042
450 mm
450 mm
575 mm
285 mm
650 g
15 - 18 V/ 1000 mA
7.4 V und 11.1 V/ 750 mA
Roll function
(Aileron function)
The roll function causes the lateral flight of the helicopter.
The control takes place with the right control lever.
If the lever is moved to the left, then the model hovers laterally
to the left. Moving the lever to the right makes the model move
laterally to the right.
Nick function
(Elevator function)
The nick function causes forwards and backwards flight of the
helicopter. The lower rotor rotation tips slightly downwards
and the model tilts around the transverse axis. When the nose
drops downwards, a part of the lift is transferred into forwards
thrust.
If conversely the nose is raised, then the model flies backward.
the control takes place with the right control lever.
Press the lever forward to introduce forwards flight, pull back to
have the model fly backwards.