Checking The Chain Lubrication; Changing The Saw Bar; Fitting The Saw Chain - FLORABEST FKS 2200 D2 Betriebsanleitung

4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear handle
and the left hand on the front
handle (8). Thumb and finger
must close securely over the han-
dles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with
the left hand. Chain should stop
abruptly.
7. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not
function correctly, you must
not use the electric chainsaw.
A slack saw chain leads to
danger of injury.
Return the electric chainsaw
to our Service-Center for re-
pair.
Checking the chain
lubrication
Check the oil level and the chain lubrica-
tion system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw is
working trouble-free.
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
J 4. Clean the oil passages of the
chain bar (25), in order to guar-
antee a trouble-free, automatic
( 1)
A

Changing the saw bar

1. Switch the saw off and unplug it
F
2. Lay the saw on a flat surface.
3. Turn the fastening bolt (14) anti-
4. Remove the saw bar (4) and saw
5. To fit the new bar, place the bar

Fitting the saw chain

1. Switch the saw off and unplug it
G
2. Spread the chain (5) out into a
3. Slide the saw chain (5) into the
4. Pre-tighten the chain (5) by turn-
GB
oiling of the saw chain during
operation.
from the mains.
clockwise and loose the chain
adjustment ring (
A
the sprocket chain wheel cover-
ing (15).
chain ( 5). To remove the guide
A
bar (4), raise it to an angle of ap-
prox. 45 degrees. This will make
it easier to take the saw chain (5)
off the sprocket (
G
(4) onto the bar bolt (21) with
the tensioning plate pointing out-
wards (22).
from the mains.
loop with the cutting edges run-
ning clockwise .
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (23).
It is normal that the saw chain (5)
is slack. Sagging in the chain is
normal.
ing the tensioning plate (22)
clockwise.
IE CY
13) to remove
23).
15