C) Discharging Batteries ("Discharge") - VOLTCRAFT B6 Quadro Bedienungsanleitung

c) Discharging batteries ("DISCHARGE")

• After you have selected the "Pb" program in the main menu with the button "BATT.TYPE/STOP" and
confirmed this with the button "START/ENTER", you can select the discharge function using the button
"INC" or "DEC":
The value on the left in the second line shows the discharge current, the value on the right shows the voltage
or number of cells of the battery (in this example, a one-cell lead battery, 6x 2.0V = 2.0V).
• If the values need to be changed, press the "START/ENTER" button. The discharge current blinks.
Change the discharge current using the keys "INC" and "DEC" and confirm the value using the
"START/ENTER" key.
• The voltage/cell number then begins to flash. Change this using the buttons "INC" and "DEC". You
should be aware while doing this that the voltage only changes with the number of cells (e.g. one cell =
2.0V, two cells 4.0V etc.) Confirm the setting by pressing the "START/ENTER" button.
For safety reasons, the charger sets the final discharge voltage automatically.
• To begin the discharge process, keep the "START/ENTER" button pressed for longer (approx. 3 sec-
onds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appro-
priate information is shown on the display.
• You can stop the warning signal by pressing the "BATT.TYPE/STOP" button. You then return to the pre-
vious configuration menu.
• If you press the button "Start/Enter" during the discharge process, the discharge current can be
changed (see above).
• Once the discharge process is complete, an audio signal is emitted.
If you wish to terminate the discharging process beforehand, press the
"BATT.TYPE/STOP" button.
61