Connections - Ecler IC6 Bedienungsanleitung

IC6
•
2 way speaker for false ceilings
•
6.5" polypropylene woofer
•
25mm tweeter
•
Power: 40W RMS@8Ω
•
Sensitivity (1W/1m): 88 dB SPL
•
Built-in transformer.
•
External diameter: 204mm
•
Cut out diameter: 180mm
•
Installation system: Three revolving fasteners
IC8
•
2 way speaker for false ceilings
•
8" polypropylene woofer
•
25mm tweeter
•
Power: 60W RMS@8Ω
•
Sensitivity (1W/1m): 89 dB SPL
•
Built-in transformer.
•
External diameter: 245mm
•
Cut out diameter: 222mm
•
Installation system: Three revolving fasteners
Note: If you use the speaker for false ceiling in 70V installations, the power for the 100V position will
be half the amount shown on the switch. When used in 50V installations, it will be a fourth of the
amount.
Each model in the series comes with a protective grill that can be removed with a hook
included in the package. Be careful not to damage the speaker when removing the grill.

4. CONNECTIONS

The connection terminals for models IC6
and IC8 are of the pressure clamp type for
bare cable. Once connected, just select the
mode and working power of the unit with a
simple screwdriver. Always respect the
polarity.
In the IC3 model, the connection terminals are screw-type terminal blocks. Connect the cables as
follows:
• between "0" and "8 / 10W" terminals (negative and positive, respectively) if your amplifier is of low
impedance
• between the "COM" terminals and "6W or 3W or 1.5W @ 100V" (negative and positive,
respectively) if your amplifier is of high impedance, thus directly selecting a working power for the
IC3 unit
The IC series are shipped from factory with the switch in 100V/70V position. If it is
connected to a low-impedance amplifier, the speaker will not be damaged, but will perform
way below its full potential. If the speaker is accidentally connected to a 100V/70V line in the
8Ω position, it will be severely damaged.
5