Sage the Oracle BES980 Kurzanleitung Seite 15

OPERATING YOUR NEW APPLIANCE
'Hrd3' will flash on screen. Machine is now
in Water Hardness mode. See 'Water Hardness
(Hrd3)' to set.
Descale (dESc)
Select this feature to access the step by step
descale procedure on the LCD.
Water Hardness (Hrd3)
Rotate SELECT dial to the required setting from
'Hrd1' (softest water) to 'Hrd5' (hardest water).
Press SELECT dial to set. Machine will beep once
to confirm selection.
Units (SEt)
Set units to metric or imperial.
LCD Backlight (Lcd)
Adjust the LCD brightness / contrast.
Spotlights (SPOt)
Adjust the brightness of the LEDS lighting
the drip tray area. Rotate SELECT dial to the
desired brightness. Press SELECT dial to set.
Steam Temperature (StEA)
Adjust the steam boiler temperature, which in turn
controls steam pressure. Rotate SELECT dial
to the desired temperature. The default is 130˚C.
Press SELECT dial to set.
Air Pump Delay (Air)
Delay the operation of the air pump during
automatic milk texturing. Rotate SELECT dial
to the desired delay time.
Sound (Snd)
Adjust the audible alerts. Rotate SELECT dial
to the desired setting. Select between off (OFF),
low (Lo) or high (Hi). Press SELECT dial to set.
Fan Control (FAn)
Adjust the speed of the internal cooling fan. Rotate
SELECT dial to the desired fan speed. Select
between Silent (SILt), Standard (StNd) or cool
(CooL). Press SELECT dial to set.
Disable Clean Me! Alert (Cln)
Disables the 'CLEAN ME!' alert. Rotate SELECT
dial to on (On) or off (OFF). The default setting is
on. Press SELECT dial to set.
12h or 24h Clock (CLoC)
Display time in 12h or 24h format. Rotate SELECT
dial to the desired unit. Press SELECT dial to set.
Flow Measurement Method (VoL)
Select between volume based (FLo) or time based
(SEc) method for espresso dose measurement.
Rotate SELECT dial to the desired method. Press
SELECT dial to set.
ALERTS
MANUAL will flash on steam LCD
The machine will not reach operating temperature
(STANDBY mode) if the steam lever is in the
MANUAL position. The steam LCD will display
'MANUAL'. Lower the steam lever to the centre
OFF position.
Steam operation is ready when the SELECT
dial illuminates.
Fill Tank
The machine will detect a low water level.
The LCD will display 'FILL TANK'.
Clean Me!
Indicates when 200 extractions have been carried
out since the last cleaning cycle.
The cleaning cycle cleans the shower screen and
back-flushes the group head.
EN
15