Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Setting (fig. E)
A
Hammer
Drill in masonry, concrete and natural
stone.
B
Hammer drill
Drill in masonry, concrete and natural
stone. Don't use the hammer drill
function for ceramic tile or other mate-
rial that can not withstand impact
energy.
C
Drill
Drilling in wood, synthetic materials
and metal.
D
Chisel Rotation
Non-working position used only to
rotate flat chisel into the desired
position
E
Warning! No function mode: The
motor turns without load, the shaft
will not turn. Do not set the switch
like this. It may damage the motor
greatly.
• Turn the drill selection switch (5) and
the hammer selection lever (8) to the
required position.
Hints for optimum use
9.3
• Clamp the workpiece. Use a clamping
device for small workpieces.
• Firmly hold the machine by the grip.
• Set the operating mode.
• Switch on the machine.
• Do not apply too much pressure on the
machine. Let the machine do the work.
• Switch off the machine and wait for the
machine to come to a complete stand-
still before putting the machine down.
8
7062733-SDS_Plus_Hammerdrill-Ma-1801-08.indb 8
10. Cleaning and maintenance
Operating mode
• Regularly clean the housing with a soft
• Keep the ventilation slots free from dust
10.1
(fig. A)
• Regularly grease the shaft in which the
• Regularly check the grease level inside
• Remove the cover from the lubrication
• Remove the cap from the lubrication
• If necessary, add some grease into the
• Mount the cap to the lubrication point
• Mount the cover to the lubrication point
10.2
If an increased brush sparking occurs, it is a
sign that the carbon brushes must be
replaced. Have the carbon brushes replaced
by a professional.
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the
mains.
cloth.
and dirt. If necessary, use a soft, moist
cloth to remove dust and dirt from the
ventilation slots.
Lubrication
accessories must be inserted.
the machine:
point (6) using the spanner (14).
point (6).
lubrication point (6).
(6).
(6) using the spanner (14).
Checking and replacing the carbon
brushes
16-03-18 12:42
Werbung
Inhaltsverzeichnis
