WARNING - PROPERTY DAMAGE!
►
Do not use abrasive or caustic cleaning agents. These can attack the
surface and damage it beyond repair.
NOTICE
►
Ideally, clean the appliance directly after cooling, so that milk residues can
not dry onto it.
For the fi rst coarse cleaning put some water and a little mild detergent into
the carafe (the whisk used 4/8 is still fi tted). Thereby, pay heed to the
MIN and MAX
Start the appliance so that the whisk ploughs 4/8 through the water.
Afterwards, rinse the appliance out with copious clean water.
For a thorough cleaning, proceed as follows:
Remove the whisk 4/8 from the appliance to clean it and clean the inside
■
of the appliance with warm water. Add a little detergent. Wipe the interior
with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse the appliance out with copious clean water.
Pull the sealing ring 3 off of the lid 1 and clean both parts in mild soapy
■
water. Remove detergent residues with clean water and dry both parts well.
Push the sealing ring 3 back onto the lid 1, so that the outwardly facing
sealing lip is located at the bottom of the lid 1 and the inwardly facing seal-
ing lip engages in the groove of the lid 1.
Clean the whisks 4/8 in mild soapy water and then rinse them well with
■
clean water.
Clean all exterior surfaces, the plinth 6 and the power cable with a damp
■
cloth. In all cases, dry the appliance well before using it again. For stubborn
soiling use a mild detergent on the cloth. Ensure that there are no detergent
residues located on and in the appliance before taking it back into service.
Storage
■
Let the appliance cool down completely before putting it into storage.
Wrap the power cable around the cable winder 7 under the plinth 6.
■
■
Store the appliance at a dry location.
SMA 550 A1
Do not clean the appliance or parts of it in the dishwasher!
If you do so, the appliance will be damaged beyond repair.
- markings.
GB
IE
9